Elesta RTM501B Mode D'emploi page 25

PROBABLE CAUSE:
REMEDY:
SYMPTOM:
PROBABLE CAUSE:
REMEDY:
SYMPTOM:
PROBABLE CAUSE:
REMEDY:
SYMPTOM:
The device is signalling a fault because it has detected
the wireless thermostat or chronostat batteries to be
running low.
Replace the batteries of the transmitters concerned.
Carefully read the instructions of the transmitters for
further information.
1
The led Fig. 1 on the front panel of the receiver
blinks red continuously.
The channels in question are in an "alarm status" due
to the absence of radio communication.
Check the radio communication again using the "test"
function on the transmitter. Assess whether the
devices need to be moved away from metal shields or a
"repeater" needs to be installed.
The transmitter is in the "test" mode but the module
fails to switch on any relay.
The address sent by the transmitter does not
correspond to the address memorised in the receiver.
Carry out the "self-learning" procedure as directed in
the section "Configuring the System".
The transmitter is in the "test" mode but the receiver
fails to switch on any relay. The LED does not
25