Electrical Connections - Elesta RTM501B Mode D'emploi

- Make sure that the device is not powered (no mains power supply applied).
- Remove the cover using the screwdriver as a lever on the plastic tabs, shown
2
with in Fig. 1-2-3, pressing down lightly between the tab and the hole in
the plastic, without pushing down directly on it to avoid it breaking.
- Once the best place for installation has been identified (for signal reception),
fix the bottom of the receiver to the wall using two screws and the two holes
spaced 60 mm apart.
While working with tools in proximity to electronic components,
carefully check that the circuit is disconnected from the 230V~ mains
power supply and take care not to damage circuits or components.
- Make the electrical connections as directed in the paragraph on "Electrical
connections".
- Close the device, placing the cover on the base, making sure that the hole is
towards the LED, then press down lightly until the four plastic tabs click.
- Configure the device as explained in "Configuring the system".

ELECTRICAL CONNECTIONS

This section shows how to connect the receiver correctly: carefully read the
directions below and refer to Fig. 5-6, which show the arrangement of the
terminals and how they are connected internally.
Terminals 1 and 2 are the receiver's power inputs: connect them to the 230V~
mains supply, making sure that terminal 1 is connected to neutral.
Terminals 6, 7 and 8 are SPDT type connectors of the output relay.
In Figure 5 is shown how to connect a valve, which will be powered once the
20