Elesta RTM501B Mode D'emploi page 22

in the slot visible in
enabled: the receiver's LED will blink quickly yellow.
- As soon as a test command is received, the LED associated with the channel
will remain steadily lit yellow for 7 seconds. During this time the module will
continue to receive test commands and memorise only the signal received
with the highest strength. This means that it will memorise the signal coming
from the nearest transmitter and will thus avoid learning addresses from any
transmitters in the test mode which are not meant to be connected to the
system.
- After 7 seconds have elapsed the procedure will be terminated and the
corresponding LED will blink red-green-red-green in sequence to indicate that
the transmitter address has been saved.
- The module will resume normal operation and the output relay will immediately
start to switch ON and OFF every three seconds following the commands
emitted by the transmitter in the "test" mode.
- When using the "test" function it is advisable to check the strength of the
signal received placing the transmitter in the desired position. To avoid wrong
indications due to overlapping signals, do not test more than one transmitter
at a time.
- After verifying that the signal strength is satisfactory, you may proceed with
the final mechanical and electrical installation.
Checking the signal strength
The device constantly indicates the strength of the radio signal received. This
makes the whole system simpler to install and adjust and moreover allows the
4
of Fig.1. This is how the self -learning procedure is
22