Using The Radio - Denon Professional DN-700AV Guide D'utilisation

Playing Audio Files on a USB Flash Drive
A USB flash drive can be connected to the USB port of this unit to play music and still picture (JPEG) files. Only
USB drives conforming to mass storage class and MTP (Media Transfer Protocol) standards can be played on
DN-700AV, in the FAT16 or FAT32 format.
Supported file formats: WMA (Windows Media Audio), MP3 (MPEG-1 Audio Layer-3), WAV, MPEG-4, AAC,
FLAC (Free Lossless Audio Codec), JPEG.
To play audio files on a USB flash drive:
1. If the unit is off, press the Power button to power it on.
2. Connect your USB device (mass storage class) to the USB port.
3. Select Multimedia as your desired media type and use the Cursor ◄ and ► buttons on the remote control to
select USB.
4. Select a file from the list displayed on DN-700AV or your TV/monitor.
To move through audio files or folders, press the Cursor ◄ and ► buttons using the remote. Press Enter to
open a folder or to select an audio file to begin playing.
Playing Audio from a Bluetooth Device
1. If DN-700AV is powered off, press the Power button to power it on.
2. Use the Source Select knob to select Bluetooth.
3. Press the Bluetooth button.
4. Navigate to your Bluetooth device's setup screen, find "DN-700AV" and connect.
To disconnect a paired Bluetooth device, press and hold the Bluetooth button for 3 seconds. Alternatively,
use the Source Select knob to select another playback source to disconnect pairing.
Note: If your Bluetooth device prompts for a pairing code, enter 0000.
Using the Dock Audio Inputs for Media Playback
1. If DN-700AV is powered off, press the Power button to power it on.
2. Connect your media device to the Dock inputs on DN-700AV.
3. Press Dock on the remote control or use the Source Select knob to select Dock as the audio input source.
4. Start playback from your media device and adjust the source volume.

Using the Radio

To use the radio:
1. If DN-700AV is powered off, press the Power button to power it on.
2. Use the Source Select knob to select Tuner. The audio from the broadcast will start automatically.
Important: Make sure you have properly connected the FM antenna.
3. To select a radio station, use the Tuner -/+ buttons on the unit or the Tuning -/+ buttons on the remote
control.
To save/recall a radio station preset:
1. Select a radio station using the Tuner -/+ buttons on the unit or the Tuning -/+ buttons on the remote
control.
2. Press the Mem button on the remote control, then press the Tuning -/+ buttons to select a preset memory
location. Press the Mem button again to save the radio station to the selected location.
3. To recall a saved radio station, press the Station +/- buttons to cycle through the saved radio station memory
locations.
9