MESTIC MCCHD 33 Mode D'emploi page 10

ENGLISH
Control
1. Switching on and off: press and hold the on / off button, the refrigerator will now start or switches off
2. Temperature adjustment: press the
3.Fast cooling / energy saving mode: press the set button"
energy saving mode ECO. Green is Eco and blue is MAX
4. Switch C to F: In standby mode, hold down the "
Celsius temperature, (F is Fahrenheit temperature, C is Celsius temperature), after releasing the
Key 3 seconds automatically save the setting and exit.
5.USB charging port: In standby state, press "
protection gear setting menu, and then press "
protection
Battery power detection
The device features a multi-level battery guard that protects your vehicle battery from excessive discharge when the
device is connected to the built-in DC power supply. If the cooler is operated with the vehicle ignition off, the cooler
will shut off automatically when the power supply voltage drops below a set level. The cooler will turn back on once
the battery is charged to the restart voltage level. The compressor will restart automatically in a few minutes when the
voltage returns to normal values.
Note: these values are measured at the input of the control unit and / or at the DC connection.
1. Battery protection function for the cooler with three-class battery protection function, can automatically check
the battery voltage of the vehicle, before the electricity consumption will affect the normal functions of the car.
The cool box will stop automatically to ensure that the car's battery does not run out.
2. Method for adjusting the battery protection:
Tip: It is recommended to set the H-class when the cool box is connected to a vehicle, otherwise the car's battery
may be too empty and affect the normal ignition of the car; When connecting the cool box to an external or backup
battery, it is recommended to set the M-mid range so that the cool box can work longer.
or button to adjust the temperature, The temperature is now set.
" to quickly switch between cooling mode MAX and
" and " " key for 3 seconds to switch Fahrenheit and
" and " " for 3 seconds at the same time to enter the battery
" or " " to set the corresponding battery