Dometic COOLMATIC MDC 065 Notice D'utilisation page 15

MDC
➤ Connect the cooling device
– As directly as possible to the pole of the battery or
– To a plug socket which is fused with at least 15 A (at 12 V) or 7.5 A (at 24 V).
A
NOTICE!
Disconnect the cooling device and other power consuming devices
from the battery before connecting the battery to a quick charging
device.
Overvoltage can damage the electronics of the device.
The cooling device is equipped with an electronic device to protect against
reversing the polarity and short circuits when connecting to a battery. To protect the
battery, the cooling device switches off automatically if the voltage is insufficient
(see table below).
Switch-off voltage
Switch-on voltage
Connecting to 230 V mains supply
D
DANGER!
• Never handle plugs and switches with wet hands or if you are
standing in a puddle.
• If you are operating your cooling device on board a boat with
a mains connection of 230 V from the land, you must install a ground
protection circuit breaker between the 230 V mains supply and the
cooling device.
Seek advice from a trained technician.
➤ To operate the cooling device with a 230 V mains supply, use an CoolPower
EPS100W or MPS35 rectifier.
EN
Setting up and connecting the cooling device
12 V
10.4 V
11.7 V
24 V
22.8 V
24.2 V
15