Dust Extraction - Bosch JS470E Consignes De Fonctionnement/Sécurité

BM 2610008439 06-11:BM 2610008439 06-11 6/17/11 10:46 AM Page 8
BLADE INSTALLATION AND REMOVAL
This jigsaw is equipped with a Bosch tool-less
blade changing system for fast and easy
changes of T-shank blades. (Note: This jigsaw
does not accept U-shank blades.)
If blade is not properly
WARNING
installed, then the blade may
unexpectedly dislodge from jigsaw when tool is
energized.
1. To remove a previously-used blade, pull
blade change lever until blade ejects.
Blade ejects forcefully when
WARNING
released. Direct away from
yourself or bystanders.
2. Pull the blade change lever to the point that
the slots on the blade clamp's ring line up with
the slot in the center of the clamp (Fig. 2).
3. Insert the saw blade (teeth in cutting
direction) until it the "T" part of the blade shank
is completely inserted in to the blade clamp.
(When inserting the saw blade, the back of the
blade must rest in the groove of the guide roller)
(Fig. 2a.)
4. When blade change lever is released, it will
spring back to its closed position.
5. Verify that the blade clamp has also
returned to its closed position (which is the
GUIDE
ROLLER
BLADE
FIG.
Assembly
1
BLADE
CHANGE
2
LEVER
BLADE CHANGE
LEVER
BLADE
CLAMP
BLADE CHANGE
RING
LEVER
BLADE
point where slots were previously).
Note: If the saw blade cannot be inserted into
the plunger, the slots of the blade holder are
not in the correct position.

DUST EXTRACTION

(Not included, available as accessory)
The JA1007 Dust Extraction Kit includes a
dust shroud and an extraction tube for
connecting the jigsaw to a vacuum hose or
vacuum hose adapter.
Note: The dust shroud must be used when the
extraction tube is connected to a vacuum
cleaner system.
To use this feature, attach extraction tube to
footplate. When inserting the extraction tube
into the footplate be sure that the plastic post
of the extraction tube engages into the
corresponding hole on the housing (Fig. 3).
For vacuuming, a Bosch Air Sweep vacuum
hose or hose adapter (optional accessory) can
be directly connected to the extraction tube
(Fig. 3).
For maximum vacuum dust pick up, dust
shroud must be attached.
DUST SHROUD
(Not included,
available as
accessory)
EXTRACTION TUBE
(Not included, available
as accessory)
FIG. 2
SLOT
VACUUM HOSE
(Not included,
available as
accessory)
-8-
FIG. 3
PLASTIC
POST