EIBENSTOCK EPG 400 A Notice Originale page 16

hands using the handles provided, stand in a safe position and
concentrate.
Tool Change
Mounting the base plate and the scratch disk:
Place the base plate or the scratch disk onto the head spindle and secure it
with the help of the provided screw.
Mounting the work disk:
Place the work disc centrally onto the Velcro plate.
The entire disk must cling to the Velcro plate to ensure that the disk is
attached securely.
Attention!
Before you start working, check whether the accessory has the exact
position. Let the machine start running in a safe position for a short
time. In case the machine does not run easily, immediately stop
working.
Instruction for use
Switch the machine on and put it carefully on the surface you want to work
on. Hold the machine with both hands and move it in a linear or rotary way.
!
Attention!
Do not touch rotating parts!
Plaster milling:
Always make sure you observe the plaster manufacturer's product
information and notes on use.
If the notes on use and the dwell times of the plasters are observed,
optimum results can be achieved.
!
Attention!
Don`t plunge the work disc into water!
Care and Maintenance
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an
electric specialist. Due to its design, the machine needs a minimum of care
and maintenance. However, the following points have to be observed:
Always keep the power tool and the ventilation slots clean.
16