EIBENSTOCK EPG 400 A Notice Originale page 13

Case including plaster milling machine with 2 pieces Li-ion battery pack
18V / 5,2 Ah, charger, base plate, sponge board and manual.
Application for Indented Purpose
When used with the appropriate equipment, the plaster milling machine
EPG 400 A is suitable for machining lime-cement- and gypsum-based
surfaces, for sgraffito purposes and for smoothening insulting boards in the
case of full heat protection. Use only original CAS (Cordless Alliance
System) battery packs.
Available Accessories
Pos. Order No. Article
1 37731000 Li-ion battery pack
2 37734000 Charger Standard
3 37732000 Quick - Charger
4 37721000
5 37722000
6 37725000
7 37729000
8 37728000
9 37724000
10 37726000
11 3772A000
12 37727000
Supply
Base plate (Klett)
Ø 370 mm
Sponge board
Ø 400 mm
Sponge rubber disk
Ø 380 mm
Felt disk
Ø 395 mm
Smoothing disk
Ø 380 mm
Scratch disk
Ø 370 mm
Plaster plane
Ø 385 mm
Scratch- and
plane Ø 370 mm
Abrasive disk corundum
P24
Ø 370 mm
charging time ca. 110 min
charging time ca. 45 min
basic holder for all Klett
disks
for smoothening lime-
cement-based plasters
for smoothening lime-
cement- and gypsum-based
plasters
for smoothening lime-
cement-based plasters
for smoothing concrete
for sgraffito purposes
for smoothening lime-
cement-based plasters
for smoothening lime-
Plaster-
cement-based plasters and
for sgraffito purposes
for smoothening insulating
boards in the case of full
heat protection
13
Application