SAFETY REMINDERS
Ventilation
•
Adequate ventilation must be
provided in the room where the
tumble dryer is located to prevent
gases from appliances burning other
fuels, including open fires, being
drawn into the room during operation
of the tumble dryer.
•
Installing the rear of the appliance
close to a wall or vertical surface.
•
There should be a gap of at least 12
mm between the machine and any
obstrubtions.The inlet and outlet
should be kept clear of obstruction.To
ensure adequate ventilation the
space between the bottom of the
machine and the floor must not be
obstructed.
•
Check regularly that the air flowing
through the dryer is not restricted.
•
Check frequently the fluff filter after
use, and clean, if necessary.
•
Prevent items from falling or
collecting behind the dryer as these
may obstruct the air inlet and outlet
•
NEVER install the dryer up against
curtains.
•
In cases where the dryer is installed
on top of a washing machine, a
suitable stacking kit must be used
according to the follow configuration.
-Stacking kit Mod 35100019: for
minimum washing machine depth
49 cm
-Stacking kit Mod 35900120: for
minimum washing machine depth
51 cm
The stacking kit shall be one of that
above, obtainable from our spare
service.
EN
6
INTRODUCTION
The instructions for installation and
any fixing attachments, are provided
with the staking kit.
Do not install the product in a low temperature
room or in a room where there is a risk of frost
occurring. At temperature around freezing point the
product may not be able to operate properly: there
is a risk of damage if the water is allowed to freeze
in the hydraulic circuit (valves, hoses, pumps). For
a better product performance the ambient room
temperature must be between +2°C and +35°C.
Please note that operating in cold condition
(between +2 and +15°C) might imply some water
condensation and water drops on floor.