Electrical Connections - Carel thT Mode D'emploi

Dismantling
Insert a screwdriver into the clot at the top and press downwards to
detach the display.
General notes
Avoid installing the terminal in environments with the following
characteristics:
•
relative humidity greater than the value specifi ed;
•
strong vibrations or knocks;
•
exposure to water sprays;
•
exposure to aggressive and polluting atmospheres (e.g.: sulphur and
ammonia fumes, saline mist, smoke) so as to avoid corrosion and/or
oxidation;
•
strong magnetic and/or radio frequency interference (for example,
near transmitting antenna);
•
exposure to direct sunlight or the elements in general;
•
large and rapid fl uctuations in the room temperature;
•
environments where explosives or mixes of fl ammable gases are
present;
•
exposure to dust (formation of corrosive patina with possible oxidation
and reduction of insulation).

Electrical connections

AC85~ 250 V 50/60 Hz
thT
L
N Power line
NO
COM Digital
output
NC
GND
B(-) Serial
connection
A(+)
N L
A+ B- Gnd NC Com NO N L
Example of network connections
thT - ID50
L
N
NO
COM
NC
GND
B(-)
A(+)
thT - ID51
L
N
NO
COM
NC
GND
B(-)
A(+)
thT - ID81
L
N
NO
COM
NC
GND
B(-)
A(+)
9
AC85~ 250 V 50/60 Hz
N L
Power line
Load
Power line
Load
Power line
Load
Serial connection
RS485 Modbus
"manuale thT" +0300077IE - rel. 1.3 - 11.04.2016
ENG