Abus IPCB42510A Manuel Utilisateur page 92

7.5.2 Image
Overall profile:
Individually time-controlled
Brightness, contrast, saturation, hue:
Sharpness:
Iris mode:
Exposure time:
Amplification (optional):
Day/night switching:
Sensitivity:
Delay time:
Smart IR:
WDR:
Wide dynamic level:
HLC:
White balance:
Digital Noise reduction:
Noise reduction level:
Mirroring:
Vertical display:
Scenario pre-settings:
Video standard:
Image settings and image optimisation functions apply for the
day and night profiles
Image settings and image optimisation functions can be
separately configured for day and night profiles
Adjust these values to suit the ambient conditions.
set the electronic oversharpening for the image (edge
overdraw)
choose between manual and automatic iris control, depending
on your model. If only one mode is available, then it is the only
mode offered.
select a value for the fixed exposure time.
The higher the value is, the lighter the image is in poor lighting
conditions and therefore the higher the image noise is.
Select a method for switching between day and night mode.
Day: the camera stays in day mode.
Night: the camera stays in night mode.
Auto: Automatic switching according to light conditions
Schedule: switching at fixed times. You must enter the day start
time and day end time.
Triggered by event: switching is performed by triggering the
switching input. The output status can be achieved via the
status option if the input is not triggered.
the higher the value is, the darker it must be for the camera to
switch to night mode.
delay in seconds until switching to day or night mode.
Prevents glare effects from objects that are too close when
IR lighting is enabled.
wide dynamic function for improved display of high contrasts.
The WDR level should be reduced if the image displayed is too
bright.
select the WDR level. A higher level may increase image noise.
Glare around the edge of bright light sources is reduced (e.g.
car headlights). A higher threshold means high reduction.
Function only with deactivated WDR.
Select between different variants of white balance.
Function for reducing noise in the image. The higher the value,
the more noise is removed and the more static the image
appears.
select the DNR level
H: Horizontal mirroring (left/right)
V: Vertical mirroring (up/down)
Hor. + Vert.: Horizontal and vertical mirroring
This setting rotates the image to increase the vertical angle of
view. It is necessary to rotate the camera module by 90° when
doing this.
These two indoor/outdoor options are used to configure certain
pre-settings for the two scenarios in the camera.
Here you can set the mains frequency of the power supply
network.
92