Dometic COOLFUN CK 40D Hybrid Notice D'utilisation page 11

CK40D Hybrid
➤ To switch off the cooler:
– Disconnect the plug.
– Wind the cable around the two holders on the back of the device for storage.
I
NOTE
Disconnect the cooler from the battery when the engine is not running,
as otherwise the battery will run down.
Connecting the cooler to 230 V (compressor mode)
➤ Connect the 230 V connection cable (see figure) to the 230 V AC mains supply.
➤ Switch the cooler on by pressing the "ON/OFF" button (fig. 2 2, page 3).
✔ The Display switches on and shows the current cooling temperature in °C.
✔ The cooler starts cooling the interior.
➤ To switch off the cooler:
– Press the "ON/OFF" button (fig. 2 2, page 3).
– Disconnect the plug.
– Wind the cable around the two holders on the back of the device for storage.
✔ The display switches off.
Setting the temperature
The cooling capacity can be influenced by:
• The ambient temperature
• The number of wine bottles to be cooled
• The frequency with which the door is opened
➤ Press the "TEMP –" button (fig. 2 3, page 3), to decrease the desired cooling
temperature by 1 °C.
➤ Press the "TEMP +" button (fig. 2 4, page 3), to increase the desired cooling
temperature by 1 °C.
✔ The cooling temperature set at °C then appears in the display for a few seconds.
✔ The device acknowledges the chosen temperature's acceptance by flashing the
display.
EN
Operation
11