Door Reverse - Signature SCV190IXNF Instructions D'utilisation

DOOR REVERSE

This freezer has been built with the door hinges on the right. If you want
to change the opening direction, please follow the instruction below.
WARNING: When reversing the door, the appliance must not be
connected to the mains. Remove the plug from the mains beforehand.
(1)
(2)
(3)
1. Remove the cover of the
screws(1), and unscrew the
screws(2), then remove the top
cover.
2. Remove the decoration of
the top cover(3), and fix it on
the opposite side.
3. Unscrew the upper hinge (4)
(4)
and remove it.
(5)
4. Unscrew the upper hinge
pivot (5) and place it on the
opposite side.
5. Push the door up to remove
it. Put the door to one side and
l a y i t d o w n g e n t l y o n a
padded surface.
6. Remove the hinge pin (6)
that is in the bottom of the
door. Turn it over and insert it at
the other side of the door.
7. Lay the appliance on a
padded surface. Remove the
b o t t o m
(6)
a d j u s t a b l e f o o t ( 8 ) , t h e n
change the hinge axes to left
hole. Position and fix the lower
hinge by screws.
8. Lift up the appliance to
vertical position and fix the
upper hinge then adjust the
door on the horizontal level
and fix the screws.
9. Position and screw the top
cover, laying the appliance on
an appropriate place.
(7)
(8)
-25-
h i n g e ( 7 ) a n d