Bosch wallSCANNER D-TECT 100 Instructions D'emploi page 19

Changing the Measurement Indication
When the unit is positioned against the wall, pressing the "mode" but-
ton 8 supports alternating between three different modes and therefore
three different measurement displays. Mode selection supports adapt-
ing the unit to different wall materials and to ignore insignificant objects
(e.g. hole structures in brickwork). The current setting ("mode S",
"mode 1" or "mode 2") is shown on the display.
mode Especially
suitable for
S Brickwork,
hollow blocks
1 Concrete,
solid blocks
2 Light construc-
tion, flooring,
gypsum plaster
board
mode S
The standard setting after switching the unit on is suitable for most ap-
plications. Objects up to a depth of 6 cm are displayed. Hollow space
structures of brickwork or empty plastic pipes with a diameter of less
than 2.5 cm are possibly not displayed. Exit this mode only when deep-
er drilling is necessary (change to "mode 1") or when very many or large
objects are displayed indicating a light construction wall (change to
"mode 2").
mode 1
"mode 1" is suitable for measurements in consistent wall materials (e.g.
concrete). Objects (including hollow spaces) up to a depth of 10 cm are
displayed.
mode 2
"mode 2" is suitable for measurement in materials with several layers on
top of each other (e.g. light construction, flooring) or many hollow spac-
es (e.g. gypsum plaster board). Electric wiring, metals and water-filled
pipes are displayed primarily up to depth of 4 cm, but not wood and
large hollow spaces. Measuring these materials with "mode S" or
"mode 1" would display too many insignificant objects, e.g. hollow
spaces in light construction walls.
1 609 929 C66 • (02.09) T
Measuring
depth displayed
6 cm
10 cm
4 cm
English–6
Objects displayed
Plastic pipes, steel
pipes, mains circuits,
wooden beams, etc.
As in "mode S", addi-
tionally hollow spaces
Only mains
metal pipes and water-
filled plastic pipes
circuits,