HQ DIGICHAR100 Mode D'emploi page 5

is fully charged. If the red LED (14) is flashing when the battery is
installed, it indicates that the batteries are non-rechargeable alkaline
batteries or aging Ni-MH rechargeable batteries.
Note:
This charger will not charge a single Ni-MH battery, it must be
charged in pairs.
6. USB Port Charging
All hand-held devices, which are charged with tip connectors via USB
DC 5V can be charged by this charger. Connect the device to (17) USB
port. The blue LED (16) will light up. When the charging is completed,
the blue LED (16) will turn off or flash.
7. Power Transfer & Charging Mode
Insert a fully charged spare battery into the battery tray and secure
connections, the blue LED (13) will light up; then plug in any USB
rechargeable hand-held device into the USB port (17). The blue LED
(16) will light up. The charger starts transferring the spare battery as
power source via 5V USB to charge any USB devices. When charging
is completed, the blue LED (16) will turn off.
Notes:
-
To avoid over discharge, please remove the spare battery as soon
as the blue LED (13) is off.
-
When 2 AA/AAA batteries are used as power source in power
transfer mode, the red LED (14) will stay on.
-
When the blue LED (13) turns off, it indicates that the battery may
be exhausted or the USB rechargeable hand-held device has been
fully charged.
8. Manual Rejuvenating Function (REVIVE)
When the blue LED (13) stays off after correct connection, it indicates
the following:
A The spring contactors do not make correct contact with the battery
connectors. Please re-adjust the spring connectors with battery
connector until the blue LED (13) turns on.
OR
B If the battery has not been used for a long time or when it is over-
discharged, place the inside spring contactors with the positive (+)
5