Additional Information - ecofort HeatBAR Mode D'emploi

Circuit
breaker
Active
Neutral
Earth
All irradiation heaters are designed to achieve and maintain a certain thermal
comfort to the people who need it both outside and inside. It is therefore very
important to carefully study the area where people stay and consequently direct
the radiation towards them.

Additional information

– Under no circumstances turn the appliance on if it is on any
surface.
- A safety distance of not less than 100 cm should always be left
in front of the heaters or too near.
- The appliance must not be located neither directly below, nor
in front of a socket-outlet.
- The heater must be installed so as to prevent that the switches
can be touched from those who are in the shower.
- Avoid the use of an extension cord with this product, because
the extension cord may overheat and cause a risk of fire.
- Ensure that there is no possibility of inflammable material,
combustible material or curtains coming into contact with the
heater, or lie near the heater.
RCD Fuse*
HeatBAR
27
* 10A (mod. 9815 - 9818)
16A (mod. 9824 - 9832)