Brandt BWT6410E Guide D'installation Et D'utilisation page 20

EN 4 / PROGRAMMING YOUR MACHINE
•DETAILS OF THE PROGRAMMES
•Rinsing
A separate rinse followed by a choice of:
— Either spin and drain
— Or drain only ("Drip-dry" option)
— Or a stop with the drum full of water.
• Spinning
This allows a separate spin and drain.
Important:
In the case of "Rinse only" followed by a spin or "Spin only",
ensure that you select a suitable spin speed for the type of washing
in the machine.
•Flash 30 min
This programme enables you to refresh a small load of 2.5 kg of lightly
soiled washing composed of WHITES, COTTONS, COLOUREDS or
HARD-WEARING SYNTHETICS.
The cycle time is restricted to around 30 minutes
In this programme, the washing temperature is automatically programmed
at 40°C.
Important:
For this programme, the doses of detergent should be
reduced by half.
•DETAILS OF THE OPTIONS
•Prewash
Specially designed for heavily soiled washing (mud, blood, etc.).
A specific initial agitation in cold water precedes a phase of heating to
30°C.
This agitation phase in cold water enables the particles soiling the washing
to be removed before the water is heated.
Important:
Detergent must be placed in the " " container in the products
box (see the section "LOADING THE WASHING PRODUCTS").
•Save time
Allows for a reduction in the cycle time according to 2 levels that can
be accessed by pressing on the button several times. Level 1, reduces
the average time by 20%. Level 2 reduces the average time by 40% for
laundry that is only lightly soiled.
•Rinse plus
"Especially for sensitive and allergic skin": adds an extra rinse to the
washing cycle.
•Easy ironing
This option washes your laundry more gently, but with an identical
washing performance. The spin speed is slower so that your laundry
creases less.
•Drip dry ( )
This function, for very delicate linen, enables you to remove spinning and
to pass directly to the draining of the washing machine.
•Full drum stop (
(continued)
This function enables you to remove the washing from your machine
before the spin phase or to delay this phase with you washing remaining
in water to prevent creasing.
NB: When the machine stops with the drum full
of water, the "Spin" cycle progress light (
flashes and the remaining time displayed is
"00:00".
Then:
— Either you want to drain after spinning.
In this case, use the button (
for your type of washing.
The programme will end automatically.
— Or you just want to drain.
In this case, use the button
speed "
•Delayed start
You can delay the start of your programme to use off-peak electricity or
to avoid your washing standing in the drum for too long at the end of
the cycle.
To do this, press the button "
By repeatedly pressing the (
to delay the cycle start (in increments of 1 hour).
NB:
- The "
- The time remaining before the cycle start is counted down by the hour
until 1 hour and then by minutes from 59 minutes to 1 minute.
succession
At the end of the waiting period, the programme starts and the machine
counts down the time remaining before the end of the cycle.
20
)
) 3
3 to select the "Drip Dry" function (spin
").
+
" 5 .
+
) button, select the time by which you wish
-
" button can be used to go backwards.
Information:
Throughout the whole waiting period, four elements light up in
)
to choose a suitable spin speed