Brandt BWT6410E Guide D'installation Et D'utilisation page 18

EN 4 / PROGRAMMING YOUR MACHINE
•PROGRAMMING
•Programming a washing cycle
— Select immediate start by pressing "Start/Pause"
— ... or select a start delayed using buttons
OPTIONS • Delayed start").
•Adding or removing an item during the cycle
— Press the "Start/Pause" button
— Add or remove the items of laundry
The time the lid remains locked depends on the temperature inside the machine and, for safety
reasons, may take several minutes if you are interrupting a cycle at more than 40 °C.
— Press the "Start/Pause" button
N B: If you have selected a delayed start, you can access the drum instantly at any time in the period
before the washing cycle starts without having to interrupt and restart the cycle.
•Cancelling while programming, washing or during a pause:
to the " O " position.
— Set the selector 1
NB :
- In all cases, after cancelling you must reprogramme everything from the start.
- If you have cancelled during the washing phase, remember to empty the water, if necessary. To do
this, select a "Spin" programme by setting the speed to "
•End of the cycle:
N B: After spinning, your machine automatically position the drum opening at the top to provide easy
access to the washing. This operation lasts at most 3 minutes.
— The machine then displays "StOP", indicating that the cycle has finished, the display will switch off
automatically after a few minutes in order to save energy in standby mode
Set the selector 1 to the "O" position.
You can now open the lid and remove your washing.
•Maintaining your machine's performance
You must clean the drain pump filter regularly (for how to do this, see the section "CLEANING THE PUMP FILTER").
Important :
Your machine's performance can be affected if you do not clean the pump filter regularly.
For more details on the various functions, please refer to the sections "DETAILS OF THE PROGRAMMES" and "DETAILS OF THE OPTIONS".
Information:
After a power failure, when the power is restored, the washing cycle automatically resumes at the point where it was interrupted.
:
(continued)
6 ...
5 (for how to do this, see the section "DETAILS OF THE
(impossible during spin):
6 to interrupt the cycle.
to restart the cycle.
6
".
(Maintaining the pump filter):
18
Display
The phase of the cycle the machine is in
is displayed throughout the cycle...
... along with the remaining cycle time.
An animation (four small elements
turning on themselves) shows the waiting
period before the start of the cycle.
Countdown of the time is stopped and
cycle progress and "Remaining time"
lights flashing
alternately.
Resumption of the countdown and lights
stop flashing and
remain lit.
All displays are off.