Discontinuing A Measurement; Memory Recall; Recall The Memory With The Power Off; Clear Measurements From Memory - Be.Better RX808 Mode D'emploi

3.3 Discontinuing a Measurement

To stop the measurement (eg. the patient feels unwell) press the START/STOP button. The device will immediately
decrease the cuff pressure automatically.

3.4 Memory Recall

This blood pressure monitor automatically stores 30 measurements in its memory. The oldest record will be
replaced by the latest measurement value when there are more than 30 sets.

3.5 Recall the Memory with the Power Off

Press and hold the START/STOP button for 3 seconds when monitor is turned off, the average of the last 3
measurements will be shown, press the START/STOP button again to see the most recent measurement value.
Subsequest measurements can be displayed one after the other by pressing the START/STOP button.

3.6 Clear Measurements From Memory

If you are sure that you want to permanently remove all stored memories, press and hold the START/STOP button
for 10 seconds until "CL" appears when the monitor is off. Press the START/STOP button "CL" will flash 3 times to
clear the memory. After this, press the START/STOP button for 10 seconds, the symbols "
on the screen. This means that the memory has successfully cleared.
3.7 Hypertension Classification Indicator
The bars on the left hand side of the screen show you the
range within which the indicated blood pressure values lies.
Depending on the height of the bar, the readout value is
either within the normal (bar 1-2), borderline (bar 3-4) or
danger (bar 5-6) range.
The classification is based on standards adopted from
WHO (World Health Organization); which is recognized by
Hypertension Canada.
The indicator bar rises according to your measurement.
• If your measurement has only one or two bars, your
measurement is in "Normal" range according to the
WHO classification.
• If your measurement has three bars, it is in the high
normal range according to the WHO classification.
• If your measurement has four bars, it is in the "Stage 1 Hypertension" zone.
• If your measurement has five bars, it is in the "Stage 2 Hypertension" zone.
• If your measurement has six bars, it is in the "Stage 3 Hypertension" zone.
" and "no" will appear
SYS
180
6
160-180
5
4 140-160
130-140
3
2 120-130
120
1
WHO
World Health Organization 2003
DIA
(mmHg)
110
100-110
90-100
85-90
80-85
80