Beurer MP 64 Mode D'emploi page 24

– Blue LEDs light up on the surface of the device depending on the select-
ed speed.
– All filing and callus attachments are coated with a sapphire grain. This
guarantees a long service life and ensures practically no wear.
– Do not press too hard and always carefully move the attachments to-
wards the area to be treated.
– Move the device over the area to be treated and apply slight pressure
while slowly moving the device in circles.
– Please note that the callus attachments show reduced performance on
soaked or wet skin. For this reason, we ask that you do not soak the foot
in water before treatment.
– To maintain natural skin protection, do not remove all calluses.
– Ensure the axle can always rotate freely. The axle must not be permanent-
ly blocked, as otherwise the device will become too hot and may become
damaged.
– Apply moisturiser to the treated areas after each use.
The device switches off if an attachment is prevented from moving for
approx. 3 seconds during use. To restart the device, switch it briefly off
and then on again.
Important:
Check the results during the treatment. This applies in particular
for diabetics as they have less sensitive hands and feet.
Attachments
Since the attachments are of a professional quality and improper use can lead
to injury, we ask that you handle the attachments carefully. At high speeds in
particular, we advise that you proceed with caution.
The following attachments are included with the device:
1 – Fine-Grain Sapphire Wheel
Suitable for filing nails to reduce length. Whilst
the sapphire disk rotates, the external housing
remains fixed to prevent friction burns to the skin
around the nails.
24