Overview Of The Components; Setting The Temperature - Clatronic HL 3631 Mode D'emploi

• The radiator should not be placed directly below a mains power
socket.
• The radiator should only be used in an upright position.
• Do not try to repair the appliance on your own. Always contact an
authorized technician. To avoid the exposure to danger, always
have a faulty cable be replaced only by the manufacturer, by our
customer service or by a qualified person and with a cable of the
same type.

Overview of the Components

1 Handle
2 Function control knob
2a = Fan (oscillating)
2b = 1000 Watt (oscillating)
2c = 1500 Watt (oscillating)
2d 0 = Off
2e = Fan
2f = 1000 Watt
2g = 1500 Watt
2h 0 = Off
3 Temperature control
4 Filter
5 Foot
6 Safety switch
7 Grille for heating elements
8 Indicator lamp
Instructions for use
Unpacking the appliance
1. Remove the appliance from its packaging.
2. Remove all packaging material such as foils, padding,
cable holders and cardboard.
3. Fully unwind the cable.
NOTE:
There might be dust and production residue present on the
appliance. We recommend cleaning the device as described
under "Cleaning".
Electric connection
• Make sure the voltage of the appliance (see rating label)
matches the mains voltage to be used.
• Set the control knob to 0.
• Connect the mains plug to a properly installed isolated
ground socket.
28
HL3631_IM_new
Connected load
The appliance supports a power input of 1500 W.
CAUTION: Overload:
• When using an extension cord, it must have a cable
cross-section of at least 1.5 mm².
• Do not use multi-outlet power strips, since this appliance
is too powerful.
• Do not connect any other powerful devices to the same
electric circuit.
Safety switch
Your radiator features a safety switch that disconnects the
power supply in case the appliance falls over. The safety switch
prevents hazards caused by overheating.
WARNING:
Place the appliance on a smooth, horizontal surface. Avoid
carpets in order to prevent failure of the safety switch.
NOTE:
The appliance turns on automatically once back in an upright
position.
Filter
There is a coarse filter located on the rear side of the appliance.
This filter collects and retains dust.

Setting the temperature

The thermostat constantly switches the radiator on and off,
thereby keeping the temperature at the desired level. Set the
desired temperature as followed:
1. Set the temperature control to its highest setting.
2. Once the desired temperature has been reached,
slowly turn the temperature control back, until the radiator
switches off audibly. The indicator lamp turns off.
03.06.16