Installation And Operation Instructions; Safety Instructions; Product Information - ensto BETA-BT Série Instructions D'installation Et D'utilisation

Beta-BT Heaters
ENG

Installation and Operation Instructions

Safety Instructions

• The heaters may only be installed by electrically skilled person.
• The power supply must be disconnected before carrying out any installation or maintenance work on this
heater.
• The instruction manual must be stored in a safe location and be available for future installation and service.
• People who are not able to operate according to the manual must not use this appliance.
• CAUTION – Some parts of this heater can become very hot and cause burns. Particular attention has to be
where children and vulnerable people are present.
• Children of less than 3 years should be kept away unless continuously supervised.
• Children aged from 3 years and less than 8 years shall only switch on / off the heater provided that it has
been placed or installed in its intended normal operating position and they have been given supervision or
instruction concerning the use of the heater in a safe way and understand the hazards involved. They shall
not plug in, regulate and clean the heater or perform user maintenance.
• If the supply cord is damaged, it must be replaced by the manufacturer or electrically skilled person.

Product Information

• The heaters are intended for permanent installation on the wall rack included in the package, figures 1.1
- 1.4.
• WARNING - In order to avoid overheating, do not cover the heater, figure 1.5.
• Do not install the heater immediately below a socket outlet, figure 1.5.
• Connect the heater according to the wiring diagram, figures 2a and 2b.
• External voltage has to be connected to terminal 4, if you want to be able to use external temperature
control.
• The heaters are double-insulated, class II. Separate earth is not required.
• The dripping water protected BETA IP21 heater must not be installed in places in which it can be subjected
to spraying water.
• The splashproof BETA IP24 heater must not be installed in places in which it can be subjected to water jets.
• When the BETA heater is installed in a bathroom, the switch and other controls must not be within the
bather's reach.
• The heaters are equipped with an electronic thermostat.
• The auxiliary energy consumption is less than 0,5W.
• Radio frequency range is 2,4 ... 2,483 GHz.
• Radio maximum power is +3 dBm.
LED indicators
LED indicator C
LED indicator B
LED indicators C
and B
10
Green: thermostat is on, heating is off
Red: heating is on
Blue blinking: pairing is ongoing
Blue blinking quickly: factory defaults are resetting
Blue: temperature change
Red and blue blinking alternately:
faulty sensor
RAK124 / © Ensto 2019