Connecting To The Machine (With Cable); Configuring The Smart Compact Payment Box; Establishing Connection Between Transmitter And Coffee Machine; Uninstalling The Smart Compact Payment Box - Jura 579 A Mode D'emploi

Smart Compact Payment Box

Connecting to the machine (with cable)

T
Switch off coffee machine at power switch.
T
Move switch for accounting mode to
bottom position (payment mode).
T
Connect RS232 cable to coffee machine.
E
If using the intelligent fresh water kit:
Connect RS232 cable to Mini Hub of intelli-
gent fresh water kit.
T
Insert the mains plug into a power socket.
T
Switch on coffee machine.
3 Configuring the Smart Compact
Payment Box
The process for configuring the Smart Compact
Payment Box (e.g. machine selection) is explained
below.
Precondition: The PC software of the Smart
Compact Payment Box is installed and up to date.
T
Switch off coffee machine at power switch.
T
Remove Smart Compact Payment Box's
mains plug from power socket.
T
Remove RS232 cable (if connected).
T
Connect Smart Compact Payment Box to PC
with the USB cable.
T
Plug Smart Compact Payment Box's mains
plug into power socket.
The Smart Compact Payment Box switches
on.
T
Configure Smart Compact Payment Box
with the PC software.
E
The instructions for use for the PC software
are contained in the software.
T
Remove USB cable.
The Smart Compact Payment Box switches
off again. The changes will be applied the
next time it is switched on.
T
Reconnect RS232 cable (if cable connection
is wanted).
T
Switch on coffee machine.
E
Prices can be set and changed at any time.
The coffee machine and Smart Compact
Payment Box do not have to be switched off.
12
4 Establishing connection between
transmitter and coffee machine
E
JURA Smart Connect must be fitted in the
coffee machine.
E
The distance between the Smart Compact
Payment Box and coffee machine must not
exceed 0.5 m.
T
Briefly press reset button of the Smart
Connect (e.g. with a pen).
The LED flashes.
T
Then (within 30 sec.) press the transmitter's
reset button.
The LEDs light up to indicate that a connec-
tion has been established.
E
If a connection cannot be established
between Smart Connect and the transmitter,
they may be too far apart (max. 0.5 m) or
there may be machines in between which
are affecting the signal.
5 Uninstalling the Smart Compact
Payment Box
T
Move switch for accounting mode to top
position (non-payment mode).
T
Wait approximately 5 seconds.
T
Switch off coffee machine at power switch.
T
Disconnect the mains plug.
T
Remove RS232 cable (either on the coffee
machine or on the Mini Hub of the intelli-
gent fresh water kit).

6 Accounting mode

Switch for accounting mode:
Z
Top position:
U
Machine is in non-payment mode
U
Status LED flashes
Z
Bottom position:
U
Machine is in payment mode
U
Status LED on continuously
E
The accounting mode must not be changed
while a drink is being prepared.