System Setting; Event Log; Demo - FULGOR 700 Série Guide D'utilisation Et D'entretien

With the oven on, press the
menu. This menu permits setting of parameters or special
functions. It also permits accessing the error events list.
1. Press the keys to select the sub menu and confirm with
the key.
START
2. Use this menu to change the following settings:
Press the keys to select the item to be set or to be
displayed from among the three available ones and
confirm with the key.
START
SYSTEM
EVENT LOGS
MAIN VOLTAGE

DEMO

OM 15

Event Log

The menu permits checking any recorded errors. These codes
can be notified to the after-sales service.
EVENT LOGS
01 12/11/2015 07:06 CODE: F10305
02 17/11/2015 13:17 CODE: F10305
key to access the SYSTEM
SET

11 - System setting

Main Voltage
The purpose of this option is to set the type of appliance power
supply during installation. Press the keys
or 208V according to the mains supply in your home and then
confirm with the key.
START
To avoid accidentally changing these settings, a double
confirmation is required.
ADVANCED
MAIN VOLTAGE
Demo
The purpose of this function is to set the DEMO mode, which
makes the oven useless for cooking but automatically performs
a demonstration of functions.
1. Press the keys to select the item ON.
2. Confirm with the key.
START
3. Press the key
ON/OFF
After about 30 seconds, the oven starts to operate in this mode.
To temporarily stop the DEMO function, simply keep any key
pressed for a few seconds until the oven switches to standby.
To start it again, press the
ON/OFF
To disable the function, enter the DEMO display page and set
OFF. Confirm using the
START
NOTE: Once set, the function remains enabled even if the
oven is disconnected from the power mains.
DEMO
to select 240V
240
key.
key.
ON
EN
15