Wlan - Abus TVIP41550 Manuel Utilisateur

Multicast allows data to be sent efficiently to many recipients at the same time in IP networks. This is made
with a special multicast address. In IPv4, the address range 224.0.0.0 to 239.255.255.255 is reserved for
this purpose.
The following multicast settings can be configured for streams 1 - 4 in the video server.
Enable "Always multicast" to use multicast.
"Multicast group address" Specifies a group of IP hosts which belong to this group
"Multicast video port" This port can be different from the default port 5560. The port number must always
be even.
"Multicast RTCP video port" This port must be the "Multicast video port" plus 1.
"Multicast audio port" This port can be different from the default port 5562. The port number must always
be even.
"Multicast RTCP audio port" This port must be the "Multicast audio port" plus 1.
"Multicast TTL" Time to Live
If you are setting up port forwarding in a router, all ports should always be forwarded this way
(RTSP + HTTP). This is imperative for successful communication.

7. WLAN

You can configure the WLAN settings for the network camera here. Enter the WLAN access data and press
"Save". A progress bar will be displayed while the configuration is being saved. The status LED changes
from green to red during this process, and then back to green. Wait until this process is complete and the
camera website has been refreshed.
After completing the WLAN configuration, the camera
must be restarted with the network cable
disconnected for the change from wired to wireless
mode.
The network camera supports the WLAN standard 802.11b/g/n. The camera automatically
detects which WLAN standard is being used. In order to benefit from the high data transfer
rates which WLAN-N provides, your router must also support WLAN-N.
"SSID" (Service Set Identifier) This name identifies the wireless network. The access point and the
WLAN network camera must use the same SSID name. The factory setting is "default". IMPORTANT:
The max. length is 32 characters; do not use: „ , ", <, > and spaces.
"Wireless mode" Select one of the following options:
"Infrastructure" The network camera is connected to the network via an access point.
"Ad-hoc" In this operating mode, the network camera can communicate directly with another network adapter
(network card). A so-called peer-to-peer environment is set up.
"Channel" In infrastructure mode, the channel used is selected automatically by the camera. In ad-hoc mode,
the channel must be set manually in accordance with the other network adapter.
85
English