Brandt AD1519X Guide D'utilisation page 8

EN 2 / INSTALLING YOUR APPLIANCE
— 4pcs ST4*8 big fl at screws will be used to
install the outlet, see pic 5.
— Adjust the 4 glass screws to check
whether the glass and the cooker hood
body connected well and fi xed, see pic 6.
— Hold up the hood, 16pcs M4*10 big fl at
screws will be used to connect the hood
body into angle iron, see pic 7.
— Put the extensible pipe on the outlet;
after ensure all the things ok, put down the
hook, take from the external chimney, all the
installation is fi nished, see pic 9.
Note
—
Before installation, please ensure
the area is clean to avoid suction of the
remaining bits of broken wood and dust.
—
It cannot share the same air ventilation
tube with other appliance such as gas tube,
warmer tube, and hot wind tube.
— The bending of ventilation tube should
be ≤ 120°, parallel or above the start point
and should be connected to the external
wall.
— After installation, make sure that the
extractor is level to avoid grease collection
at one end. See Pic 10.
8
Pic 5
Pic 6
Pic 7
Pic 8
Pic 9
Pic 10