Adjusting The End Stops - RADEMACHER Rollotube RTBS Série Notice D'utilisation

Adjusting the end stops

1.
2.
3.
Zeichnung
erstellt von:
www.montageanleitung-online.de
*
NOTE
Perform a test run on the motor first, without the roller shutter curtain in place. Let the motor run
(using a time switch or a switch) in the down ( ) direction until it shuts off by itself. Please ensure
that this is the correct downward direction, or down (
If the roller blind motor is running in the wrong direction (motor running direction does not match the switch
positions for up ( ) and down ( )), switch the brown and black conductors in the junction box or switch box.
Now run the motor further in the down ( ) direction until it reaches the lower limit stop.
Assembly of the roller shutter curtain (figure
Install the roller shutter curtain (17) on the winding shaft (5) using ties (6) (accessories).
Never drill or screw into the area of
the drive to mount the roller blind.
IMPORTANT The limit stops work only if the motor is installed
in the winding shaft.
Slide the tie (6) onto the topmost segment of the roller shutter curtain (17).
a.
b. Place an tie (6) in the rectangular holes in the winding shaft (5) every 40 cm.
c. For SW 40 winding shafts (with outer seams), use hanging brackets (20) to assemble the tie (6); see
Figure .
8
IMPORTANT
The end stops for the top and bottom are adjusted by means of 2 adjustment screws. Use the included
adjustment tool to turn the screws.
End stop adjustment
adjustment screws
For right or left-hand installation: The lower end stop is set using the adjustment screw on the arrow pointing
upwards. The upper end stop is set using the adjustment screw on the arrow pointing downwards.
Turning in the + (plus) direction extends the route.
Turning the opposite way causes it to shorten.
*
The actual plus and minus directions may vary by model.
Check the printing on the motor head.
), for your roller blind.
7 / 8 )
= down
adjustment tool
= up
GB
= extension
of each route
= shortening
each route
51