Installing The Motor In The Bearings - RADEMACHER Rollotube RTBS Série Notice D'utilisation

Installing the motor in the bearings (Figure
1.
Drive bearing (13) - as a click bearing
Press the drive head (12) lightly into the drive bearing (13) until
it engages.
NOTE
The adjustment screws (11) must be accessible.
The tubular motors can be installed in the click bearing (13) in 4po-
sitions. By spreading the bracket (14), you can remove the motors
from the click bearing (13) again at any time.
Drive bearing (13) - all other bearing variants
Place the drive head (12) on the drive bearing and secure it appro-
priately, such as with a splint.
)
6
2.
Counter bearing (1)
Insert the other end of the winding shaft (5) with the ball bearing (2)
into the counter bearing (1).
If you are using a different drive bearing than the RADEMACHER
click bearing, you may now need to secure the drive with another
splint.
3. Correct for slight dimensional accuracies by sliding the roller
capsule (4) in or out.
IMPORTANT
Secure the roller capsule (4) with a screw afterward.
The roller capsule (4) must have at least 2/3 of its length inserted
into the winding shaft (5).
GB
49