Technical Specifications - HQ Power VDL3002HC Notice D'emploi

• This device is not designed for uninterrupted operation. Frequent operation breaks will prolong the life of your
VDL3002HC.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device will be protected against extreme heat, moisture and dust. Respect a min.
distance of 50cm between the VDL3002HC's light output and the illuminated surface
• Secure the device with an appropriate safety cable (VDLSC7 or VDLSC8).
• Do not use the device if the ambient temperature exceeds 45°C. The max. temperature for the housing is 130°C
• Familiarise yourself with the functions of the device before actually using it. Do not permit operation by unqualified
people. Any damage that may occur will probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• Note that all modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp
explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Lamps
• Disconnect the power supply before removing or replacing the lamps.
• Make sure the lamps have cooled fully before attempting to remove them. Never touch a quartz bulb with your
bare hands. If you accidentally touch it, you should wipe the bulb with a lint-free cloth moistened with methylated
spirit.
• Only use this lamp in equipment specifically designed for this type or rating of lamp. For certain critical
applications, we recommend the use of lighting equipment fitted with a glass cover or protective shield. The
manufacturer and distributor will not accept liability for injuries or damage resulting from incorrect use of the lamp
or from failure to use the correct equipment.
• Replace a damaged or thermally deformed lamp.
• Loosen the three screw knobs on the side of the cover and carefully push the three LAMP300MR bulbs (300W /
230V) into the sockets (do not touch the bulbs with your fingers). Close the cover and tighten the screws.
• Put the plug in a 220V-socket. The VDL3002HC starts to gyrate.
• Adjust the sensitivity with the knob on the side of the VDL3002HC.

5. Technical Specifications

Power Supply
Lamp
Fuse
Dimensions
Total Weight
Use this device with original accessories only. Velleman nv cannot be held responsible in the event of
damage or injury resulted from (incorrect) use of this device.
For more info concerning this product, please visit our website www.hqpower.com.
The information in this manual is subject to change without prior notice.
VDL3002HC_v2
Procedure
max. 230VAC / 50Hz
2 x LAMP300MR (300W/230V) or 2 x LAMP300 (Osram
not incl.)
F 5A, 250VAC (5 x 20mm) (order code FF5N)
Ø 340 x 450mm
3.5kg
4
300W/230V,
®
HQPOWER