Front Panel Features; Power Indicator - Furman PS-8RE III Manuel Du Propriétaire

LiFT (Linear Filtering Technology)
Traditional AC filters - conditioners have been designed
for unrealistic laboratory conditions. Prior technologies,
whether multiple pole filter or conventional series mode,
could actually harm audio and video performance more
than they help. This is due to the resonant peaking of their
antiquated, non-linear designs. Under certain conditions,
these designs can actually add more than 10 dB of noise
to the incoming AC line!

Front Panel Features

REAR LAMP
ON
OFF
Rear Panel Lamp ON / OFF Switch
DELAY 1, 2, and 3 Indicators
The DELAY 1, 2, and 3 indicators always show the pres-
ent state of the corresponding DELAY 1, 2, and 3 outlets.
In all cases, if the indicator is ON, the outlet is ON. If the
indicator is OFF, the outlet is OFF.
EVS Indicator
The EXTREME VOLTAGE (EVS) LED indicates the state
of the EVS detection system. This LED is normally off,
but illuminates Red when an EVS error has occurred. If
the PS-8RE III encounters a line voltage above the EVS
threshold (275 VAC) the SMP will disconnect the power
from the rear panel outlets and the EVS LED will activate.
The EVS LED will extinguish and power will be restored
when the line voltage returns to normal conditions.
DELAY 1 DELAY 2 DELAY 3
PS-8RE III
Worse still, lost digital data, the need to re-boot digital pre-
sets, or destroyed digital converters are frequently caused
by excessive voltage spikes and AC noise contaminating
the equipment ground. Furman's SMP+ with LiFT takes
another approach, ensuring optimal performance through
linear filtering and no leakage to ground.
SEQUENCE
EXTREME
POWER
PROTECTION
VOLTAGE
OK
PROTECTION OK Indicator:
Although the Furman SMP+ Filter assures protection
from transient voltage spikes and surges, nature can oc-
casionally produce electrical forces that are beyond the
capabilities of any surge suppression device to absorb
without sustaining some degree of damage. In the rare
instance where this occurs, the green "PROTECTION
OK" LED indicator located on your front panel will either
dim or extinguish completely. If this happens, the PS-8RE
III's surge protection capability has been compromised
and the unit must be returned to Furman Sound, or an
authorized Furman service center for repair.

Power Indicator

The POWER indicator is illuminated any time power
is applied to the PS-8RE III.
3
SWITCHED
MAIN POWER
10 AMPS
ON
OFF
PUSH TO RESET
AC ˜ 220-240V 50/60Hz 10A MAX
ON
OFF