Furman PS-8RE III Manuel Du Propriétaire page 11

P S - 8 R E I I I - P O W E R C O N D I T I O N E R / S E q U E N C E R
PS-8RE III SPECIFICATIONS
Maximum AC Current Rating:
• 10 Amps, 220 - 240 VAC @ 50 – 60 Hz
(Thermal breaker)
AC Cord:
• 1 mm2 x 3, 2.5 m length, IEC-C13 (Female) to
CEE-7/7 Schuko plug.
AC Inlet:
• IEC-C14 (Male) with metal wire retainer clip
AC Outlets:
• Convenience Outlet (Front Panel) 1 Switched IEC C-13
• Rear Panel Outlets: 2 Switched IEC C-13
(1 duplex),
• 6 Sequenced IEC C-13 (3 duplexes each controlled by
separate relay)
AC Surge Protection:
• Spike Protection Mode: Line to neutral, zero ground
leakage
• Spike Clamping Voltage: 376VAC peak @ 6,000 Volts
/3,000 Amps
• Response Time: 1 nanosecond
• Maximum Surge Current: 6,500 Amps
• AC Overvoltage Protection: EVS, 275VAC+/-5VAC
• AC Overvoltage Reset Modes: Auto
AC Filtering:
• LiFT
• Noise Attenuation: 10dB @10KHz, 40dB@100KHz,
50dB@500KHz
THREE YEAR
PRODUCT WARRANTY
Furman warrants to the original purchaser of this product for a
period of three (3) years from the date of purchase, that the unit
shall be free of defects in design, material or workmanship, and
Furman will repair or replace any defective unit. Full Warranty and
Policy information available at: www.furmansound.com
Operating Temperature Range:
• 5C (40F) to 40C (105F) degrees
Humidity Range: • <90% rH (Relative Humidity)
User Interface:
• Rocker Switch: Front panel, Power (ON, OFF)
• Rocker Switch: Front panel, Sequence (ON, OFF)
• Rocker Switch: Front panel, Rear Lamp (ON, OFF)
• Thermal Circuit Breaker: Front panel, pushbutton
• Front panel diagnostic indicators DELAY 1, DELAY 2,
DELAY 3, Power, EVS, and Protection OK
• Rear panel BNC Lamp connector 12VDC / ½ Amp
• Control/Status/Triggering (Rear Panel):
• Rear Panel DIP Switches: 12V Mode On/Off,
GND Mode On, Momentary/Maintained
• Potentiometer: Rear panel, time calibration fine tune
delay adjust
• Remote Terminal: +5-30VDC In, 12VDC (12mA) Out
• Remote Terminal: Phoenix type 4-Pin Connector with
Screw terminals: +12V, STAT, REM, GND (Class 2 Wiring)
Size: 44.33 mm x 482.6 mm x 165.1mm (HWD)
Mass: 3.03 Kg
Power Consumption (No Load): 10 Watts
Safety Agency: TUV
Specifications are subject to change without notice due to
product improvements and upgrades.
CAUTION! WARRANTY LIMITATION FOR
INTERNET PURCHASERS
Furman products purchased through the Internet do not carry a
valid Product Warranty unless purchased from an Authorized Fur-
man Internet Dealer and the original factory serial numbers are
intact (they must not have been removed, defaced or replaced in
any way). Purchasing from an Authorized Furman Internet Dealer
insures that the product was intended for consumer use, has passed
all quality inspections and is safe. Buying through auction sites or
unauthorized dealers may result in the purchase of salvaged and/
or failed products. In addition, Authorized Furman Internet dealers
have demonstrated sufficient expertise to insure warranty compli-
ant installations. For a list of Authorized Furman Internet Dealers
please go to www.furmansound.com
10