Furman PS-8RE III Manuel Du Propriétaire page 10

P S - 8 R E I I I - P O W E R C O N D I T I O N E R / S E q U E N C E R
Troubleshooting
PS-8REIII shows no signs of life –
no lights or activity
• Confirm that unit is receiving 220 – 240 VAC power
• Confirm that the front panel breaker is pushed in
PS-8REIII Power lamp is on, but unit does not
sequence
• Confirm that the sequence switch is in the ON
position
• Confirm that the signals present at the remote
interface allow sequencing
• If in doubt, return the PS-8REIII to factory
default settings and re-test
Compatible Furman Products
RS-1 – Remote Key
Switch
RS-2 – Remote Key
Switch w/ Push Button
PS-8REIII Power lamp is on, but PROTECTION OK
LED is dim or off
• Surge protection circuit has been damaged;
return unit to Furman authorized repair facility
for service
PS-8REIII operates, but trips circuit breaker
• Check loads on all outlets, reduce if necessary
• Check loads on branch circuit, reduce if
necessary
GN-LED LED
Gooseneck Lamp
9
GN-I – Incandescent
Gooseneck Lamp