Error Message (Cause/Remedy/Information) - Soehnle Professional 7710 Mode D'emploi

English
Print-command conditions
The print templates are assigned to print-command conditions using the service software. The following
conditions can be assigned to print templates:
• Print key
• Automatic print/data record once immediately
• Automatic print/data record once after weight change at standstill
• Automatic print/data record after weight change at standstill
• Automatic print/data record after weight change at standstill above the empty message
• Automatic print/data record after weight change at standstill above the empty message if
the empty message was previously active.
• Continuous transmission
• Enter key for input from ORG A
• Enter key for input from ORG B
• Enter key for input from ORG C
• Enter key for input from ORG D
• Plus key (F key for totalising)
• Key combination INFO, F and Print key (setting-dependent)
• Enter key for manual input
• Print alibi memory
• Print reference statistics
Error message
2 Ident chip error
4 REF weight too small
5 Zeroing not possible
6 Taring not possible
7 Not authorised to print
8 No unit switchover
9 Print signal buffer full
10 Load cell signal overflow
11 No measuring point signal
12 Measuring point number ? CAN addr
13 Converter failure
15 Measuring point write-protected
16 No measuring point detected
18 Measuring point not zeroed
20 Print format empty
23 Print error
24 Print template memory corrupt
25 No print template(s)
5 5 2 2
Cause /Remedy / Information
For Customer Service for error diagnosis
Scale unsuitable for part weight, if applicable change set
ting in setting mode
Deviation from zero point too great
Empty scale, scale in underload or overload, manual tare
input with tare value above maximum load