Battery Information - Medisana Medinose Pro Mode D'emploi

ENGLISH
Using the Medinose Pro
1. Insert the two nose adapter
2. Press the ON/OFF button
activated.
3. One treatment cycle lasts for approximately three minutes. The unit will automatically turn off
after the treatment cycle is over. If you need to turn the unit off during treatment, press the
ON/OFF button
The MEDISANA Medinose Pro can be used three to four times per day, allowing five to six hours
between each treatment.
Note: If you feel any discomfort or pain at any time during treatment, turn the unit off and stop
using immediately. Consult your doctor for advice.
How to use wire:
1. Slide the nose adapter
out of the holder on
the rear of the device.

Battery Information

Open the battery compartment cover
the back of the unit and insert 2 x AAA batteries (included),
observing correct polarity (as shown on the inside of the battery
compartment).
When the battery power is low, the light on the ON/OFF button
will flash to indicate that the battery should be replaced.
•
Remove the battery if the product is not in use for long periods of time.
• Do not mix old and new batteries or different types of batteries.
• Warning: If batteries leak and come into contact with the skin or eyes, wash immediately with
copious amounts of water.
• Batteries should be handled under adult supervision.
• Dispose of batteries safely according to the battery manufacturer's instructions.
16
into the nose as far as it is comfortably possible.
once to turn the unit on. The redlight in two wavelengths are
.
2. Unwind the wire from
the device and place
around the neck.
by pulling the hook at
3. Clip the wire into the
rear slot to secure.
Hook
4. Adjust the position of
the device on the wire.