English - Best Vintage Mode D'emploi

English

! The appliance must be installed by a qualiied person
EN
in compliance with the instructions provided.
Wear gloves when carrying out installation and
maintenance operations.
Filtering version
The hood puriies the air and recycles the clean air
back into the room. For this version, the following are
required: 1 charcoal ilter.
CONTROlS
Speed display
PU1: ON/OFF Lights
PU2: ON/OFF Motor 1
PU3: ON/OFF Motor 2
PU4: ON/OFF Motor 3
PU5: ON/OFF Motor 4
5' timer function:
Pressing PU2, PU3 or PU4 for two seconds when the
motor is set to the corresponding speed, the 5' timer
function is activated. The corresponding LED starts
blinking to display this function. After ive minutes of
operation the motor is turned off. If you change the
speed while the timer is running, the function is NOT
deactivated. To deactivate the function, press the
blinking key for two seconds.
NOTE – the 5' timer function can be activated for
the normal speeds only (1st, 2nd, 3rd)
Buzzer:
Each time the key is pressed, a beep is sounded.
Filter alarm:
After 30 hours of motor operation, the grease ilter
alarm is activated (all the LEDs come on). The alarm is
activated when the motor is off and remains displayed
for 30". To deactivate the alarm, press one of the keys
for 2" during alarm display. After 120 hours of motor
operation, the charcoal ilter alarm is activated (all the
LEDs blink). The alarm is activated when the motor is
off and remains displayed for 30". To deactivate the
alarm, press one of the keys for 2" during alarm display.
MAINTENANCE
12
st speed
nd speed
rd
speed
th
speed
! Before cleaning or maintenance cut the power.
Cleaning the hood
WHEN TO CLEAN IT: clean it at least every 2 months
to prevent the risk of ire.
EXTERNAL CLEANING: use a cloth moistened in
lukewarm water and neutral detergent (for painted
hoods); use speciic products for steel, copper or brass
hoods.
INTERNAL CLEANING: use a cloth (or brush) soaked
in denatured ethyl alcohol.
WHAT NOT TO DO: do not use abrasive or corrosive
products (e.g. metal sponges, brushes, too hard
brushes, very aggressive detergents, etc.)
Cleaning the grease ilters
WHEN TO CLEAN IT: clean it at least every 2 months
to prevent the risk of ire.
HOW TO REMOVE THE FILTERS: push the catch near
the handle towards the rear of the hood and pull the
ilter downwards
HOW TO CLEAN THE FILTERS: hand wash or in the
dishwasher using a neutral detergent. If washing in the
dishwasher, possible discoloration of the ilters does not
in any way compromise their functioning.