Installation Procedure - JVC KW-V51 BT Mode D'emploi

CONNECTION/INSTALLATION CONNECTION/INSTALLATION

Installation procedure

1
To prevent a short circuit, remove the key
from the ignition and disconnect the
battery.
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Take Connector B on the wiring harness
and connect it to the speaker connector in
your vehicle.
5
Take Connector A on the wiring harness
and connect it to the external power
connector in your vehicle.
6
Connect the wiring harness connector to
the unit.
7
Install the unit in your car.
8
·
Reconnect the battery.
9
Press the reset button.
10
Configure <Initial Setup>. (Page 4)
Installing/removing the unit
Installing the unit
46
• Bend the tabs of the mounting sleeve with a
screwdriver or similar utensil and attach it in place.
·
Installing the trim plate
Attach the trim plate (2).
Removing the trim plate
1
Engage the catch pins on the extraction
key (4) and remove the two locks on the
lower part. Lower the frame and pull it
forward.
2
2
• The frame can be removed from the top side in
1
2
• Be careful to avoid injury from the catch pins on
4
Remove the upper two locations.
the same manner.
Removing the unit
Remove the trim plate. (See the left
column.)
Insert the two extraction keys (4), then
pull them as illustrated so tat the unit can
be removed.
4
the extraction key.