D+H KA 66-TW Notice Originale page 8

Locking force adjustment
If factory-set locking pressure of aprox. 150 N is not
sufficient to close the window, it can be infinitely
increased up to aprox. 250 N.
Put in covering stopper after adjustment.
Locking force adjustment
Ø 6 mm
approx. 150 N
Mounting informations
Mount the drives mechanical
stress-free.
With that, more even load
distribution is ensured on all the
drive chains.
8/20
KA-BSY+
=
approx. 250 N
At vertical active pulling
application (e.g. for a skylight)
the forces must be rearranged
by software SCS
Shift of drive cable
Only with standard version
DIP-Switch
Only for ex-works programming
Must be switched on OFF
English
If after mounting, the measure X
is as bigger as 23 mm, null
balance with software SCS is
neccesary.
Closure Ranges will shift in
relation to new zero point.
≥ 23 mm ? X
99.823.90 2.6/10/18