Installing The Wheels; Bolt (3/8 X 4.25 In.); Spacer; Lock Nut (1/4-20) - Homelite UT903655DA Manuel D'utilisation

INSTALLING THE WHEELS

See Figure 4.
Wheels are provided to assist in moving the generator to the
desired location and should be installed on the same side
as the recoil starter.
 Locate the following items:
2 Wheels
2 Bolts (3/8-16 x 4.25 in.)
2 Spacers
2 Lock Nuts (3/8)
 Raise the end of the generator on the side opposite the
recoil starter to gain access to the frame bottom; securely
position props underneath to support.
 Insert a wheel spacer into the center of the wheel.
 Slide bolt through the wheel spacer, then through the
wheel mounting hole on the frame.
 Install nut on bolt and tighten securely.
 Repeat the process on the other side to install second

wheel.

INSTALLING THE HANDLE BRACKET
See Figure 5.
 Locate the following items:

Handle Bracket

2 Bolts (1/4-20 x 1.5 in.)
2 Lock Nuts (1/4-20)
 Place the handle bracket on the generator frame on the
side where the recoil starter is located.
 Slide the bolts (1/4-20 x 1.5 mm) through the holes in the
handle bracket and generator frame; install lock nuts and
tighten securely.
ASSEMBLY
ATTACHING THE HANDLE ASSEMBLY
See Figure 6.
 Locate the following items:

Handle

Bolt (1/4-20 x 1.5 in.)

Lock Nut (1/4-20)

 Place the handle on the handle bracket.
 Slide the bolt (1/4-20 x 1.5 mm) through the handle and
handle bracket; install lock nut and tighten securely.
WARNING:
Do not attempt to lift the unit by the handle assembly. If
it is necessary to lift the generator, always grasp by the
frame. Use proper lifting techniques to avoid back injury.
Page 12 — English