Installing The Wheels - Homelite Série UT905700 Manuel D'utilisation

INSTALLING THE FRAME SUPPORT
See Figure 4.
Install the frame support on the bottom of the generator
frame on the same side as the handle.
 Locate the following items:
Frame support
2 flange nuts (5/16-18)
2 washers (5/16 in.)
2 bolts (5/16-18 x 1 in.)
 Raise the end of the generator where the recoil starter
is located high enough to gain access to the frame bot-
tom; securely position props underneath to support.
 Align the holes on the frame support with the holes on
the generator frame.
 Slide a washer on the bolt, then insert the bolt through
the hole in the generator frame so it extends down
through the frame support.
 Install flange nut and tighten securely.
 Repeat on other side.

INSTALLING THE WHEELS

See Figure 5.
Wheels are provided to assist in moving the generator to
the desired location and should be installed on the side
opposite the handle.
 Locate the following items:
2 bolts (3/8-16 x 4-1/4 in.)
6 washers (3/8 in.)
2 spacers (.38 ID)
2 wheels
2 lock nuts (3/8-16)
 Raise the end of the generator opposite the handle high
enough to gain access to the frame bottom; securely
position props underneath to support.
 Insert a wheel spacer into the center of the wheel.
 Place a washer on the bolt, then slide bolt through the
wheel.
 Thread another washer on the bolt, then slide the bolt
through the U-bracket frame on generator.
 Place a washer on end of bolt.
 Install nut on bolt and tighten securely.
 Repeat the process on the other side to install second
wheel.
ASSEMBLY
ATTACHING THE HANDLES
See Figure 6.
 Locate the following items:
2 handles
2 bolt (5/16-8 x 3/4 in.)
4 washers (5/16 in.)
2 lock nuts (5/16 in.)
2 handle bracket spacers
 Place handle and spacer on the frame.
 Place a washer on a bolt, then slide bolt through the
handle, the frame and the spacer.
 Install nut on bolt and tighten securely.
 Repeat the process on the other side to install second
handle.
SECURING THE HANDLES
See Figures 7 - 8.
 Locate the following items:
2 handle lock pins
2 lanyards
 Attach the lanyard to the handle lock pin and the handle
as shown in figure 7.
 Insert the pin through the hole in the handle and the
generator frame to secure handle in place.
WARNING:
Do not attempt to lift the unit by the handle assembly. If
it is necessary to lift the generator, always grasp by the
frame. Use proper lifting techniques to avoid back injury.
Page 12 — English