Electrolux SG182N Notice D'utilisation page 71

Problem
The appliance is noisy.
Acoustic or visual alarm is
on.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the "FastFreeze",
or after changing the tem‐
perature.
Door is misaligned or inter‐
feres with ventilation grill.
Door does not open easily. You attempted to re-open
Possible cause
The mains plug is not con‐
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The appliance is not sup‐
ported properly.
The cabinet has been re‐
cently switched on.
The temperature in the ap‐
pliance is too high.
The door is left open.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The FastFreeze function is
switched on.
The compressor starts af‐
ter a period of time.
The appliance is not level‐
led.
the door immediately after
closing.
ENGLISH
Solution
Connect the mains plug to
the mains socket correctly.
Connect a different electri‐
cal appliance to the mains
socket. Contact a qualified
electrician.
Check if the appliance
stands stable.
Refer to "Door Open
Alarm" or "High Tempera‐
ture Alarm".
Refer to "Door Open
Alarm" or "High Tempera‐
ture Alarm".
Close the door.
Refer to "Control Panel"
chapter.
Wait a few hours and then
check the temperature
again.
Refer to "Installation" chap‐
ter.
Allow food products to cool
to room temperature be‐
fore storing.
Refer to "Closing the door"
section.
Refer to "FastFreeze func‐
tion" section.
This is normal, no error
has occurred.
Refer to installation instruc‐
tions.
Wait at least 30 seconds
between closing and re-
opening of the door.
71