Sunbeam 2356 Mode D'emploi page 7

The dough hook with the small washer
and foot goes into the socket on the
side of the mixer nearest the side of
the bowl. The other dough hook with
the large washer goes into the socket
nearest the center of the bowl. See the
dough hook symbols located on the
front of the mixer head.
Beater-Bowl Drive Adjustment
Automatic bowl rotation is factory set.
Occasionally, a simple adjustment
may be necessary when the bowl
fails to rotate.
To make this adjustment, tilt the mixer
head back. Hold the mixer head in an
upright position and locate the
adjustment screw on the underside
of the mixer head. Loosen the locking
nut and turn the adjustment screw on
the underside of the mixer head.
Loosen the locking nut and turn the
adjustment screw clockwise, to lower
the mixer head; or counter clockwise,
to raise the mixer head. Retighten the
locking nut. The beater with the nylon
button should lightly touch the bottom
of the mixing bowl.
Adjustment
Screw
About the Worklight Feature
Some of our models have a
worklight that lights the area
inside the mixing bowl.
As soon as the electric cord is
plugged in, the worklight will glow.
It will continue to glow until the
electric cord is unplugged from
the electrical outlet.
Operating Instructions
About the Mix-Finder® Dial
The Mix-Finder
the mixer ON and OFF and for selecting
its 12 mixing speeds.
Rotate the Mix-Finder
direction, to increase mixing speed;
and in a counterclockwise direction,
to decrease mixing speed.
As you rotate the Mix-Finder
notice that a numbered speed
is aligned with the indicator on top
of the mixer head. This numbered
speed indicates the speed at which
the mixer is operating.
Rotate the Mix-Finder
indicator is opposite the numbered
speed you wish to use.
Locking
Speed
Nut
Indicator
Mixing
Guide
6
Worklight
®
dial is used for turning
®
dial in a clockwise
®
dial,
®
dial until the
®
Mix-Finder
Dial