CB, RHD
➤ Wipe off the defrosted water.
Switching off and storing the cooling device
If you do not intend to use the cooling device for a long time, proceed as follows:
➤ Turn the knob to "0".
➤ Disconnect the power cable from the battery or pull the DC cable plug out of the
rectifier.
➤ Clean the cooling device (see chapter "Cleaning and maintenance" on page 15).
➤ Leave the lid or door open for to avoid unpleasant odours building up.
9
Cleaning and maintenance
!
WARNING!
Always disconnect the device from the power supply before you clean
and service it.
A
NOTICE! Risk of damage
• Never clean the cooler under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooler.
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any dust and
dirt, so that heat can be released and the device is not damaged.
➤ Make sure that no water drips into the sealing. This can damage the electronics.
➤ Wipe the cooling device dry with a cloth after cleaning.
EN
Cleaning and maintenance
15