Unpacking / Standard Accessories - Bradley Aerix+ 2921-W00000 Mode D'emploi

Unpacking / Standard Accessories

1. Remove all packing material. Recycling is recommended.
2. Carefully remove the hand dryer from the shipping carton, using care not to drop
the appliance.
3. Inspect carefully for any damage that may have occurred during transit. Check for
any loose, missing or damaged parts. If the hand dryer is damaged or missing
parts, promptly inform the dealer where you purchased it or contact BRADLEY
Standard items included with the hand dryer are:
Installation
CAUTION
Improper mounting could result in personal injury or property damage.
1. Ensure the selected installation location provides sufficient reach for the hand dryer's power cable to a 120VAC,
60 Hz polarized wall outlet.
2. Use the mounting template provided to mark the locations for the (4) wall mounting anchors to attach the wall
mounting bracket to the wall.
3. It is recommended that at least 1 of the 4 mounting anchors for the unit be fastened into a wall stud or support.
4. To use the hollow wall anchors included with the wall mounting kit, pre-drill the wall in the marked locations using
a 5/16" (8mm) drill, insert the plastic anchors and tap flush to the wall.
5. Complete the attachment of the wall mounting bracket to the wall with the (4) mounting anchors using a No.
25 torx screwdriver.
6. Hang the hand dryer on the bracket. Remove water collection tray from bottom of dryer, and complete the
attachment of the dryer with the 4th anchor.
7. Replace the water collection tray.
8. Plug the power cord into a 120VAC, 60 Hz polarized wall outlet.
Bradley • P20-199 Rev. A; ECN 13-15-013
Cleaning Brush
User Manual
Manual
HEPA Filter Cartridge with Odor
Neutralizing Tablet
3
Installation Template
Wall Mounting Bracket with
mounting anchors
12/4/2013