Pairing The Device; Aux Function; Receiving/Rejecting Calls - THOMSON WS06IPB Mode D'emploi

Pairing the Device:

1. Place the speaker near the Bluetooth-enabled device and switch the speaker on.
2. Press and hold the Bluetooth button to put the speaker into pairing mode if it is not already in
search mode. The LED next to the Bluetooth logo will start flashing.
3. Go to the Bluetooth settings on your device.
4. Select the Bluetooth name "WS06IPB ". If your device asks for a passcode enter '0000'
5. The Bluetooth LED remains fully lit when pairing is complete and a sound prompt confirms it is
paired.
6. The speaker will automatically pair to the last device it was paired to when it powers on again. If no
known device is found, it will enter pairing mode again.

Aux Function:

For other compatible music player devices, or MP3 players, please use the auxiliary audio line cable
(included) to connect from your external device's "LINE OUT" jack to the "AUX-IN" jack of this speaker.
The speaker will beep when a cable is attached and the left side LED will slowly flash.

Receiving/rejecting Calls:

While in wireless mode, press the Call button to accept an incoming call.
Press the Call button again to end the call.
You can also recall the last used number by pressing this button.
You only can reject a call from your device and not from the speaker.
Please check below for the full LED light status indications.
Note that if the speaker is only operating on battery, the Blue \ Red LED will only display the blue
colour.
Working status
Power on
Bluetooth pairing mode
Bluetooth connected
successfully
Play music
Pause
Make call via Bluetooth
AUX In Mode
USB charging for other
device
Use AC adaptor to charge
speaker
Speaker full charged
Put the Phone on wireless
charging area
Phone full charging
Bluetooth LED Indicator
(Blue/Red)
Blue\ Red LED quickly
Flashing
Blue \ Red LED quickly
Flashing
Blue LED constant
Blue \ Red LED slow Flashing
Blue LED constant
Blue LED constant
Blue \ Red LED light flash
No change according to the
current state
Red LED constant ,Blue LED
No change according to the
current state
Red LED off
No change according to the
current state
No change according to the
current state
- EN 5 -
Wireless charging LED
Indicator (Green/Red)
Red LED constant
No Change
No Change
No change
No change
No change
No change
No change
No change
No change
Green LED constant
Red LED constant