Pelgrim OVG 214 Notice D'utilisation page 56

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

During the service, you can come across
some troubles that in most cases result
from improper handling of the appliance
and can easy be eliminated.
The appliance fails to operate after
connecting to the mains supply
Check the voltage in the socket and see if the
appliance is switched on (green signal lamp is
on).
Sound alarm, red signal lamp is on
If the temperature within the freezer is too high, it is
signaled by the red signal lamp and the sound alarm,
which may be switched off by pressing the alarm off
button (3). When the lamp goes off the interior of
the freezer has again reached the appropriate
temperature.
Another increase of temperature within the freezer is
again signaled both by the red lamp and the sound
alarm.
The reasons for this may be the following:
The door was frequently opened or it was left
opened for too long.
The door is not properly closed (the door may
sag, the gasket may be polluted or damaged).
Power supply has been interrupted for a longer
period of time.
Perhaps you have overloaded the appliance with
fresh foods.
The alarm sounds, red lamp is off
Excessive dust on the condenser or around the air
circulation openings in the bottom rail may set off
the sound alarm. It may be switched off by pressing
the alarm off button (3).
Clean the condenser and the air circulation openings
in the bottom rail (consult the Section Cleaning of
the Appliance).
Cooling system is operating
continuously
Continued operation mode is on (yellow lamp is
on).
Press the button (2) and switch the continued
operation mode off (yellow lamp goes off).
Insufficient cooling of compressor and condenser.
This is signaled by the sound alarm.
Check the air circulation through the bottom rail
openings and if necessary clean or vacuum the
dust from the condenser. See Section Cleaning
and Maintenance.
The door is hard to open
If you want to open the door that has just or
recently been closed, you may find it hard to open.
The reason why this happens is, that when you open
the door, warm air gets into the appliance and when
it is cooling, the underpressure seals the door. After
few minutes (5-10), the door can easily be opened.
Noise
Cooling in refrigerating-freezing appliances is enabled
by the cooling system with compressor, which
produces noise. How noisy the appliance is depends
on where it is placed, how it is used and how old the
appliance is.

Publicité

Table des Matières
loading

Table des Matières