LaserLiner SuperPlane-Laser 3D Pro Mode D'emploi page 18

5
Optional: Working with the laser receiver RX/GRX
Use an RX/GRX laser receiver (optional) to carry out levelling at great distances
or when the laser lines are no longer visible. To work with a laser receiver,
switch the line laser to hand-held receiver mode by keeping button 7 (hand-
held receiver mode on / off) pressed. The laser lines will now pulsate with high
frequency, making the laser lines darker. The laser receiver can detect these
pulsating laser lines.
1 Sek.
!
Observe the laser receiver's operating instructions for line lasers.
Due to the special optics required to generate a continuous 360° laser
!
line, the underlying technology may cause differences in brightness in
different areas of the line. This may lead to different ranges in hand
receiver mode.
18
EN
Hand receiver mode