Accessories - Storch DMS 25 PRO Mode D'emploi

Accessories

Water flowmeter
The water flowmeter is used to set the material consi-
stency in an ideal and rational manner, guaranteeing con-
stant mixing results.
1
Assembly bolt for
mounting bracket
2
Water flowmeter
Installing the water flowmeter
Loosen the threaded joint on the water supply hose at the
dosing valve (3) and uncouple the hose with the GEKA
coupling from the water inlet (5) on the mixing pipe (4).
Remove the nut on the assembly bolt for the mounting
bracket (1) on the water flowmeter (2).
First secure the water flowmeter (2) on the dosing valve
(3) with a cap nut and then on the mounting bracket and
the assembly bolt as shown above.
Align the water flowmeter (2) with the slot in the moun-
ting bracket, and bolt down.
Translation of the original instruction
The flow meter is fitted between the dosing valve and the
mixing shaft (see figure).
3
Dosing valve Mixing pipe
Connect the water supply hose to the GEKA coupling on
the water inlet (5)
The water flowmeter (2) is now ready for operation.
38
4
Water inlet
5