Fitting Instructions - Brink 2555 Instructions De Montage

GB
Couplings class
Approval number
D- Value
Max. trailers dimensions
Max. vertical load

FITTING INSTRUCTIONS:

1. Position support A on the inside of the left chassis and fix at point B with
one M10 x 35 bolts with double washers, spring washers and nut, tigh-
ten finger-tight. Fit one M10 x 35 bolt with double washer, spring was-
hers and nuts, tighten finger-tight.
2. Position the supports D and E on the outside and inside, respectively, of
the right chassis. Fit two M10 x 35 bolts with washers, spring washers
and nuts at points F. Tighten finger-tight.
3. Position the towbar and fix to supports A, D and E as shown in the
sketch, using four M10 x 35 bolts with washers, spring washers and
nuts.
4. The ball hitch is fitted to the towbar with two M12 x 65 bolts with was-
hers and self-locking nuts. First tighten the bolts at points D and E and
then do the same for the other bolts as shown in the table.
: A 50-X
: e11 00-0728
: 6,2 kN
: 1200 kg
: 75 kg
NOTE:
* Remove the insulating material from the contact area of the fitting points.
* All bolts are quality 8.8 - nuts 8. or when mentioned in fitting instructions
10.9 / 10.
* Don't forget the spring- and plain washers.
* Consult your dealer for the maximum tolerated pull weight and ball
hitch pressure of your vehicle.
* It is recommendable to retighten all fixing bolts and nuts after the towbar
has been in use for some 1000 km/600 miles.
* Do not drill through brake-or fuellines.
* Remove (if present) the plastic caps from the spot welding nuts.
Torque settings for nuts and bolts (8.8):
M10 46 Nm
M12 71 Nm (with self locking bolts)
© 2555/16-02-1997/4