Publicité
Les langues disponibles
Les langues disponibles
Batteries to choose from
9 volt lithium battery block (operating life approx. 2 year)
9 volt standard battery block ( operating life approx. 1 year)
9 volt accumulator block
Functional testing
Switching-on of operational standby mode by
actuating the key E on the membrane keypad.
The green LED indicator will flash on briefly twice, indicating
entry standby.
Enter code number O ( original ex-works setting,
also after an equipment reset).
The door handle is released for actuation for 3
seconds (in order to open the door). During the door
unlocking period the door handle can be actuated only
once.
If the door unlocking period of 3 seconds has expired without
the door having been opened, the door handle is relocked
If the code lock does not function properly subse-
quent to programming or a battery change, the battery clip
has to be disconnected from the battery again for a short
while (brief interruption of the power supply).
If this proves to be unsuccessful, see Error reset .
Programming of the code number ( maximum entry time 13
secs.)
Programming with time limit
Please pay attention when programming numbers into the
system only 5 sec. is allowed between pressing (entering)
each digit. Failure to observe this will mean that you have
to start your programming again from the beginning.
Initial programming of the master code or reinitaline
master code after a reset.
Switching-on of operational standby mode by
actuating the key E on the membrane keypad.
The green LED indicator will flash on briefly twice, indicating
entry standby.
Enter initialisation code O .
Switch on programming mode
by pressing the key P .
Enter the mastercode (programming code) with a
minimum of 2 and maximum number of 6 digits.
Confirm entry by pressing the key P and switch off
programming mode.
Example: E O P 1234 P = mastercode E 1234
e n g l i s h
9
Publicité
